Versionen im Vergleich

Schlüssel

  • Diese Zeile wurde hinzugefügt.
  • Diese Zeile wurde entfernt.
  • Formatierung wurde geändert.

...

2.1.4) Enter a descriptive profile name and then click on Next.

2.1.5 Wählen Sie im Dropdownmenü das verwendete Communication Media aus und klicken auf ) From the drop-down menu, select the communication media being used and click Next.

Info

Werden wechselnde Verbindungsmedien verwendet, so muss die Option If various media are used for the connection, select the option automatic media detection ausgewählt werden.

2.1.6 Tragen Sie als Gateway die IPv6-Adresse oder die entsprechende DNS-Adresse des Routers ein und klicken auf ) Set the Gateway as the IPv6 address or the corresponding DNS address of the router and click Next.

2.1.7 Passen Sie die folgenden Parameter an und klicken auf ) Modify the following parameters and click Next:

  • Exchange Mode: Wählen Sie im Dropdownmenü die Option IKEv2 ausmode: From the drop-down menu, select the option IKEv2.
  • PFS Group: Wählen Sie im Dropdownmenü die Option From the drop-down menu, select the option DH14 (modp2048) aus.

2.1.8 Passen Sie die folgenden Parameter an und klicken auf Weiter) Modify the following parameters and click Next:

  • Type: Wählen Sie im Dropdownmenü die Option From the drop-down menu, select the option Fully Qualified Username aus.
  • ID: Tragen Sie den in Schritt Enter the Fully Qualified Username as specified in step 1.1.8 vergebenen Fully Qualified Username ein.
  • Shared Secret: Tragen Sie den in Schritt secret: Enter the pre-shared key name as specified in step 1.1.8 vergebenen Preshared Key ein.

2.1.9 Wählen Sie im Dropdownmenü bei IP Address Assignment die Option IKE Config Mode aus und klicken auf ) From the drop-down menu, set IP address assignment to the option IKE Config Mode and click Next.

2.1.10 Klicken Sie auf Finish, um den Setup-Assistenten abzuschließen) Click Finish to close the Setup Wizard.

Hinweis

Bei Kommunikation per IPv6 darf im Split-Tunneling kein Eintrag hinterlegt werdenFor IPv6 communications, do not enter anything for split tunneling!


2.2 Manuelle Konfigurations-Schritte im ) Manual configuration steps in the Advanced VPN Client:

2.2.1 Markieren Sie das in Schritt ) Mark the profile created in steps 2.1 erstellte Profil und klicken auf and click Edit.

2.2.2 Wechseln Sie in den Reiter IPSec General Settings und wählen im Dropdownmenü bei Tunnel IP Version die Option IPv6 aus) Change to the tab IPSec General Settings and use the drop-down menu to set the Tunnel IP version to the option IPv6

2.2.3 Die Konfiguration der VPN-Verbindung ist damit abgeschlossen. Bestätigen Sie die Änderung mit einem Klick auf ) This concludes the configuration of the VPN connection. Confirm your changes by clicking OK.