Versionen im Vergleich

Alte Version 2

changes.mady.by.user LANCOM Redaktion

Gespeichert am

verglichen mit

Neue Version Aktuell

changes.mady.by.user LANCOM Redaktion

Gespeichert am

Schlüssel

  • Diese Zeile wurde hinzugefügt.
  • Diese Zeile wurde entfernt.
  • Formatierung wurde geändert.
Seiteneigenschaften


Description:
Unlike previous firmware versions, using a cellular connection as a backup with LCOS version 10.30 Rel and later requires the remote site and the mobile profile to have the same name. Otherwise, no cellular connection will be established. LANCOM Systems also recommends that the layer name should be the same too.
This article describes the steps that need to be taken to establish the cellular backup connection again.
Note:
Info

When setting up the cellular connection with the Set up Internet access setup wizard, the remote site and the mobile profile are automatically given the same name. No manual configuration changes are required.



Requirements:
  • LCOS as of version 10.30 Rel (download latest version)
  • LANtools as of version 10.30 Rel (download latest version)
  • LANCOM cellular router
  • A configured and functional Internet connection (primary connection)
  • A cellular connection already configured as backup



Procedure:
1) Open the configuration for the router in LANconfig and switch to the menu item Interfaces
->
→ WAN
->
→ Mobile profiles.
Image Removed
Image Added
2) Edit the mobile profile and give it an appropriate Name.
Important:
Hinweis

The same name must also be assigned to the remote site for the cellular connection, so be sure to use as descriptive a name as possible.

Image Removed

Image Added

3) Switch to the menu Interfaces
->
→ WAN
->
→ Interface settings
->
→ V.24/Mobile (Mobile).
Image Removed
Image Added
4) From the drop-down menu, select the mobile profile created in step 2.
Image Removed
Image Added
5) Switch to the menu Communication
->
→ General
->
→ Communication layers.
Image Removed
Image Added
6) Set the Layer name to the name you specified in step 2.
Image Removed
Image Added
7) Switch to the menu Communication
->
→ Remote sites
->
→ Remote sites (mobile/serial).
Image Removed
Image Added
8) Edit the remote site of the cellular backup and adjust the following parameters:
  • Name: Enter the name set in step 2.
  • Layer name: From the drop-down menu, select the communication layer modified in step 6.
Image Removed
Image Added
9) Navigate to the menu Communication
->
→ Call Management
->
→ Backup table.
Image Removed
Image Added
10) Set the Backup list to the Remote site that you modified in step 8.
Image Removed
Image Added
Image Removed
Image Added
11) This concludes the configuration steps. Write the configuration back to the router.