Versionen im Vergleich

Alte Version 4

changes.mady.by.user LANCOM Redaktion

Gespeichert am

verglichen mit

Neue Version 5

changes.mady.by.user LANCOM Redaktion

Gespeichert am

Schlüssel

  • Diese Zeile wurde hinzugefügt.
  • Diese Zeile wurde entfernt.
  • Formatierung wurde geändert.

...

Description:
This document describes the information that needs to be collected in order for our Support to determine the cause of this behaviorfor problems with the Wi-Fi connection.


Preparations:
1) First, check which access point the Wi-Fi device is connecting to.
Important:
Hinweis

If this cannot be narrowed down to a single access point, the following steps must be performed on all of the potentially affected access points. 

2) In LANconfig, open the configuration dialog for the LANCOM access point and switch to the menu item Wireless LAN → Trace.

3) In the field Trace MAC, enter the MAC address of the Wi-Fi device (in the format 00:a0:57:12:34:56) that is unable to authenticate in the Wi-Fi. The first three octets correspond to the vendor ID.
Info:
Info

The data that needs to be collected here includes the WLAN-STATUS trace, a number of status tables, and for several scenarios also the WLAN-DATA trace. Depending on the amount of data in the Wi-Fi, this can take up a large amount of the access point’s RAM. Filtering for the trace MAC at the hardware level means that only the packets relating to this MAC address are stored.

Image Modified



Creating the trace:
1) Start the LANtracer, connect to the affected access point and load the attached trace configuration into the trace module.
You can ignore any error messages regarding unsupported status tables and click on OK to confirm.
View file
nameWLAN
WLAN-Client-Connection.lcgImage RemovedWLAN-Client
-Connection.lcg
height150
The procedure for creating traces using a ready-made trace configuration is described in this Knowledge Base article.
2) Filter the WLAN-STATUS Trace for the affected Wi-Fi device by entering its MAC address (00:a0:57:12:34:56) into the Filter field.
Important:
Hinweis

Only the WLAN-STATUS trace should be filtered in this scenario.

Image Modified

3) Start the trace by clicking on the button with the green arrow and try to connect the device to the Wi-Fi.
4) Stop the trace by clicking on the button with the stop sign and save it.

...