...
- LCOS as of v 10.50 RU2 (download)
- LANtools as of version 10.50 (download)
- Fiber-optic connection from Deutsche Telekom
- LANCOM SFP-GPON-1 Module
- LANCOM router or Unified Firewall with SFP interface (please see the module data sheet regarding supported LANCOM devices)
...
2.4) Set up the Internet connection using the LANconfig installation wizard to set up the Internet connection. Do this in the setup wizard by selecting “SFP” as the connector used to establish the connection.
Set up the Internet connection according to the specifications of Deutsche Telekom afterwards.
2.5) Complete the setup wizard. You can now monitor the status of the SFP module in LANmonitor.
| Info |
|---|
After successful installation, the modem should be in the following state:
|
Optional: Setup with ONT installation ID (old installation method)
| Info |
|---|
If an existing modem is replaced, a so-called "Rediscover" must be executed by the Telekom, so that the new GPON module works resp. is recognized! |
If your fiber-optic connection requires an ONT installation ID or a GPON password to be configured, you can do this in LANconfig. You can obtain the GPON password from Deutsche Telekom customer service using the contact details in the fiber-optic setup link (“Glasfasereinrichtungslink”).
...
2) Leave the Serial number field at its preset value.
Status information of the GPON module:
The status information of the GPON module can be read out either in the LANmonitor under System Information → Interfaces → GPON Module or via command line in the menu /Status/PON/.
The following figure describes the respective statuses:
| Info |
|---|
If the status O3-Serial-Number is displayed, you must have the serial number of the GPON module activated by your provider (see step 1) and, if necessary, ask for the password. |
