...
1.1) Open the configuration for the router in LANconfig and switch to the menu item VPN → General → Network rules.
1.2) Go to the menu IPv4 rules.
| Info |
|---|
For reasons of clarity when operating more than four networks, LANCOM Systems recommends you create several IPv4 rules and collect these into an IPv4 rule list. Instead of the IPv4 rule, the IPv4 rule list is stored in the VPN remote site (see step 2). |
1.3) Enter a descriptive name.
1.4) Under Local networks, select the networks which are available to the router and which the remote site should be able to access.
| Info |
|---|
Instead of selecting the network objects, you can also specify the network address in CIDR notation (e.g. 192.168.1.0/24). Multiple networks are separated by a comma (e.g. 192.168.1.0/24,192.168.2.0/24) |
1.5) For Remote networks, select the VPN remote (either VPN / IKE / IPSec / VPN connections with IKEv1 or VPN / IKEv2 / IPSec / VPN connections with IKEv2).
| Info |
|---|
The VPN remote uses the IPv4 routing table (IP router -> → Routing -> → IPv4 routing table) to reference which networks it may communicate with at the other end. |
| Info |
|---|
Instead of selecting the VPN remotes, you can also specify the remote address in CIDR notation (e.g. 192.168.3.0/24). Multiple networks are separated by a comma (e.g. 192.168.3.0/24,192.168.4.0/24) |
2) Assign the VPN rule to the VPN remote:
...
2.1.1) Navigate to the menu VPN → IKE/IPSec → Connection list.
2.1.2) Change the following parameters for the VPN remote:
- Set Rule creation to manual.
- From the drop-down menu IPv4 rules, select the VPN rule created in step 1.
2.2) IKEv2:
2.2.1) Navigate to the menu VPN → IKEv2/IPSec → Connection list.
2.2.2) Change the following parameters for the VPN remote:
- Set Rule creation to manual Manual.
- From the drop-down menu IPv4 rules, select the VPN rule created in step 1.
3) Exclude duplicate VPN rules:
...