...
This article describes how the speed for the SFP ports can be set on GSon GS-23xx, GS-3xxx or XS as well as GS-51xx 45xx series switches.
Hinweis |
---|
Make sure, that access to the management IP address of the device is possible via another or an additional port. If a connection via the SFP port cannot be established, access to the switch is still possible. The port configuration has to be made before plugging in the SFP module. |
Requirements:
- LANCOM Switch of the GS-23xx, GS-3xxx or XS as well as GS-51xx 45xx series
- Any web browser for accessing the webinterface
...
2) Set the speed for the used SFP port under Mode (ports 25 - 28).
XS and GS-51xx 45xx series:
1) Go to the menu System → Port → Summary → Port Summary and click the checkbox of a SFP port (ports 1 - 8) to edit its settings.
...
2) Check the checkbox Speed and select a port speed.
Hinweis |
---|
When configuring stacking the stacking ports can be operated exclusively with the native port speed. Therefore with stacking it is not possible to use an SFP module with a lower speed than the native port speed on these ports (e.g. a 1 GBit SFP module on a 10 GBit port). |