The WLAN controller configuration contains a profile for each LANCOM access point it manages. The profiles are to be found in the
menu
menu WLAN controller
->
→ AP configuration
->
→ Access point table.
The section
for
for static IP addressesallows the IP addresses to be assignedto each access point in different ways.
Option 1:
By default, IP address assignment is configured so that
each
each access point retrieves an IP addressfrom the DHCP serveron the local network (see the figure below).
Image Removed
Image Added
Option 2:
If
a
a local IP address is entered into the fieldbut the IP parameter profileis set to the default value DHCP, the entry in the IP address field is ignoredand the access point retrieves an IP address from the DHCP server.
IMPORTANT:
Hinweis
If no IP parameter profile is selected, the configuration is invalid and the access point cannot receive a configuration from the WLAN controller!
Image Removed
Image Added
Option 3:
With the default value in
the
the IP address field (0.0.0.0)but the IP parameter profileset as one of the profiles created in the menu WLAN controller -> AP configuration -> IP parameter profiles, the access point receives an IP addressfrom the IP address range specified in the IP profile.
field IP addresscontains an IP address from theIP address range specified in an IP profileand the same IP parameter profile is selected, then the access point receives the specified IP address.