...
With the LCOS version 10.40 there was a change in the SNMPv3 engine ID. As a result, LANCOM devices on which an LCOS version 10.3x or smaller is installed are rejected when loading via SNMPv3 into the LANmonitor with the following message if the user account of the root user is used:
Entering the device access data again does not correct the behavior in this case.
...
| Hinweis |
|---|
If this behavior occurs when using a specially created SNMP user account, then you must set the authentication and encryption settings of this user to HMAC-SHA256 and AES256. You can do this via LANconfig in the Messages/Monitoring → SNMP Settings → User menu. The device does not need to be cold started.
|
