1) Open the webinterface of the switch and go to the menu Configuration → VLAN → VLAN Membership.
5) Go to the menu Configuration → VLAN → Ports, modify the tagging modes for the individual ports and click Apply.
- Port 1:
- Egress Rule: Select the tagging mode Hybrid, as the router is also set to Hybrid (see Scenario).
- PVID: Enter the VLAN ID 1 because the network INTRANET (VLAN ID 1) acts as a management network.
- Port 2:
- Egress Rule: Select the tagging mode Trunk, as the other switch is also set to Trunk (see Scenario).
- PVID: The VLAN ID can be left at the value 1. When using the Trunk tagging mode, the Port VLAN ID not used.
- Port 3:
- Egress Rule: Select the tagging mode Access, because an end device that does not support VLAN is to be connected.
- PVID: Enter the VLAN ID 1 because access to the INTRANET network requires the VLAN ID 1.
- Port 4:
- Egress Rule: Select the tagging mode Access, because an end device that does not support VLAN is to be connected.
- PVID: Enter the VLAN ID 2 because access to the PRODUCTION network requires the VLAN ID 2.
- Port 5:
- Egress Rule: Select the tagging mode Access, because an end device that does not support VLAN is to be connected.
- PVID: Enter the VLAN ID 3 because access to the GUEST NETWORK requires the VLAN ID 3.
Hinweis |
---|
Make absolutely sure, that the Port Type is set to C-port for all ports. Only with this option the regular tagging behavior is used. In the default configuration the option C-port is assigned to all ports. |
6).Go to the menu Maintenance → Save/Restore → Save Start and click Save to save the configuration as the start configuration.
Info |
---|
The start configuration is retained even if the device is restarted or there is a power failure. |