| Seiteneigenschaften |
|---|
Description:
By default, the status of a managed device is always checked when LANconfig is started. If only a few devices are managed via LANconfig, this check is completed in a relatively short time after starting the software and LANconfig can be used.
...
This document describes how to disable the device status check for a single device as well as for several devices at the same time in order to be able to use LANconfig for configuring the devices without any time delay.
Requirements:
- LANconfig as of version 9 (download)
- Optional: Text editor for editing the "lanconf.ini" file
Procedures:
1. Deactivate checking of the device status for a single device:
1.1 Right-click on the respective device and select Properties.
1.2 Deactivate the option Check the status of this unit device at start-upstartup.
1.3 Click OK.
2. Deactivate checking of the device status for several devices at the same time:
2.1 Mark the devices for which you want to deactivate the check in the device list.
...
2.3 Uncheck Check the status of this unit device at start-upstartup.
2.4 Click OK.
| Info |
|---|
As an alternative to editing in LANconfig, you can set the "Parameters" option in the "lanconf.ini" file from the default value of 1 to the value 0 for each device. Make sure that the entries after the value are retained!
|
