LANCOM routers and access points provide the following mechanisms for
monitoring lines and connections: LCP polling, Dead Pee=
r Detection, and ICMP polling. This document describes where these=
mechanisms are configured and which parameters are available.
<=
strong>Requirements:
LCP polling (line control protocol):
Command line: Path /Setup/WAN/Polling-Table/
- With the command set <remote site name> <IP address 1&=
gt; <IP address 2> <IP address 3> <IP address 4> <Ping=
-Interval> <Retries> you can enter or change your values =
(e.g. set 1und1 8.8.8.8 {Time} 5 {Try} 2).
Seq=
uence with a value of 60 seconds:
- 60 seconds go by without receiving a packet
- A DPD package is generated
- Wait 60 seconds for response
- 1st retry
- Wait 10 seconds
- 2nd retry
- Wait 10 seconds
- 3rd and final retry
- Wait 10 seconds
- Terminate the VPN connection
Command line: Path /Setup/VPN/VPN-Peers
- The command set <vpn connection name> {DPD-Inact-Timeout}=
<value> is used to enter or change a value (e.g. se=
t TEST {DPD-Inact-Timeout} 60).