Migrating existing WLAN controller installations into the LANCOM Management Cloud

Description:

LANCOM WLAN controllers offer functions such as configuration, monitoring, firmware management, layer-3 tunneling, roaming acceleration and client steering. In the long term, the capabilities of the WLAN controller will be provided by the LANCOM Management Cloud, so the future is set to be “controller-less”.

WLAN controllers and managed access points thus can be integrated into the Cloud. We recommend that you transfer the WLAN configuration from the WLC to the LMC. This avoids conflicts between the WLC and LMC configurations for the access points.

We will deal with the following typical scenarios where a WLAN controller is used to configure access points:

1) There is no Public Spot in operation and no WLC tunnels are configured.

2) A Public Spot is in operation, but no WLC tunnels are used.

3) There is no Public Spot in operation, but WLC tunnels have been configured.

4) The Public Spot and WLC Tunnels are in use.



Requirements:

• LCOS from version 10.00 on WLC and access points (download current version)
• LANtools as of version 10.00 (download latest version)
• Administrator access to a project in the LANCOM Management Cloud

Procedures:

The following applies to all scenarios:

• Once the networks are created, you also need to create locations where the networks are to be operated.

• The networks and associated devices are assigned to the locations.

• At the end of the configuration, all of the devices at a location are equipped with the new configuration by using the Roll out sites button in the Locations section.

Scenario 1: There is no Public Spot in operation and no WLC tunnels are configured

1.1) If not yet done, you first create a project in your LMC organization.

To do so, go to the navigation area, select the section Projects and click the button Create new project.

1.2) Enter your project and  specify the different  networks and their associated SSIDs.

1.2.1) To do so, go to the  navigation area, select the section Networks and click the button Create new network.

1.2.2) Once you have created your network, select it in the network table, and then select the tab Wi-Fi to setup the appropriate SSIDs for this network.

1.3) SSIDs that are set up on the same network direct the Wi-Fi clients into the same IP network. This means that the Wi-Fi clients of the various SSIDs are able to see one another.

1.4)  If you require the SSIDs to form separate networks, you need to create an additional network as described in step 1.2. Note that additional networks need to have a unique VLAN ID.

1.5) You can now use LANconfig or WEBconfig to deactivate the WLC function of your WLAN controller.

1.6)  If not done already, carry out a firmware update to LCOS version 10.00 or later on all of the LANCOM access points.

1.7) Perform a reset on all of the managed LANCOM access points so that they are reset to their factory settings. Instructions on performing a reset are available in the following Knowledge Base document.

1.8) The final step is to  pair the LANCOM access points with the LANCOM Management Cloud (see this video).

Scenario 2: A Public Spot is in operation, but no WLC tunnels are used

2.1) First, perform  all of the steps described for scenario 1.

2.2) Once you have performed all of the steps from scenario 1, go to the Networks section and select the network to be used for the Public Spot. We used the network INTRANET in this example.

2.3) Make sure that this network has an unencrypted SSID for use by the Public Spot users.